Skip to content
  • There are no suggestions because the search field is empty.

Connect/Gateway panel guide: Tyco Minerva 8/16E/80

Equipment required

  • A Nimbus Connect or Fixed Gateway device

  • 3 core screened data cable

  • A Nimbus supplied Tyco Minerva panel connector (part no 201-302-01)

Panel configuration

  1. Set the baud rate to 4800

  2. Enable Communication Port

    1. Panel Type

      1. Has Printer

        1. 80 Column

Wiring

Connect the Tyco Minerva panel connector to the PL3 serial port on the interface board.

Using 3 core screened data cable wire to the Nimbus RS232 as follows.

Panel connector Nimbus RS232
0V Ground
Tx Rx
Rx Tx